Kenwood GP-610A Instruction Manual page 31

4 T o t a I S y s t e m
Adjustment
To obtain the necessary accuracy when the power supply i s c o n t r o l l e d by using
this component, adjustment should be done in advance.
* Aging
Before s t a r t i n g adjustment, connect t h i s component to the c o n t r o l l e d power
supply and perform aging for at least 30 minutes.
* Offset adjustment
The f u l l - s c a l e voltage ( c u r r e n t ) output corresponding to the controlled power
supply i s set from the GP-IB bus.
FS semi-solid v a r i a b l e r e s i s t o r on the panel of GP-610A/D.
the COARSE (coarse adjustment) and FINE ( f i n e adjustment) VRs are provided for
ful 1-scale adjustment.
When channel A i s used, use VR ®
When channel B i s used, use VR ©
When channel C i s used, use VR ©
A d j u s t m e n t
Power
output
F u l l - s c a l e adjustment i s done by using the
on the panel.
on the panel.
on the panel.
2 8 -
CP-IB input
For output A and B,