Kenwood GP-610A Instruction Manual page 9

• Note on connect i ng the s h o r t bar
When t h i s component i s used in a combination w i t h a f l o a t i n g c i r c u i t type
power supply (PD or PA s e r i e s ) , normal operation may not be done depending
on connect ion of the short bar i f the power input cord of the PD or PA power
supply i s the 3-pin type.
In t h i s case, connect the short bar on the power supply (PD or PA s e r i e s ) as
shown below.
Normal use
Short bar
* Connect the short bar
between the + terminal
and GND or remove i t
as shown at r i g h t .
• Output r i p p l e / n o i s e
When this component i s connected to the controlled power supply, the output
r i p p l e / n o i s e of the s t a b i l i z e d DC power supply may increase compared with
the output r i p p l e / n o i s e of the independent s t a b i l i z e d DC power supply.
Because the power supply i s a f f e c t e d by w i r i n g and the output r i p p l e / n o i s e
of this component i s amplified by the s t a b i l i z e d DC power supply.
Use in the master/slave mode
(power supply on the s l a v e )
GND
- 6 -
Short bar
* Be sure to remove the
short bar.