Wear Block Kit
TX 1000 Wide Track Compact Tool Carrier
Model No. 136-5821
This product contains a chemical or chemicals known to the State of California
Safety
Safety and Instructional
Decals
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or missing.
1. Read the Operator's
Manual.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
136-5750
2. Tension block guide
Register at www.Toro.com.
WARNING
CALIFORNIA
Installation
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Remove any attachments from the machine.
3. Engage the parking brake.
4. Lower the loader arms so that they are
approximately 20 to 25 cm (8 to 10 inches)
above the frame.
5. Shut off the engine and remove the key.
6. Raise the machine off the ground until you
can access the inside of the track beneath
the machine. Support the machine using jack
decal136-5750
stands.
Note:
Refer to the Operator's Manual for your machine
to determine the weight.
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
Form No. 3414-689 Rev A
Installation Instructions
Use jack stands rated for your machine.
Original Instructions (EN)
All Rights Reserved *3414-689* A
Printed in the USA