Toro TX 1000 Installation Instructions Manual page 3

4. Remove the outer front wheel
Figure 4
1. Nut
2. Washer (2)
5. Remove the track at the top of the inner front
wheel, peeling it off the wheel while rotating the
track forward. (Figure
6. When the track is off the inner front wheel,
remove it from the drive wheel and road wheels
(Figure 3).
7. Remove the front road wheel
Figure 5
1. Bolt (5/8 x 8-1/2 inches)
2. Front road wheel
(Figure 4).
g217640
3. Outer front wheel
4. Track
4).
(Figure 5).
g217543
3. Nut (5/8 inch)
4
Installing the Track Guides
Parts needed for this procedure:
2 Template
4 Track Guide
12 Button-head bolt
2 Hex-socket-head bolt
2 Nut
2 Thread-locking compound
Procedure
Note:
Complete the procedure for both track frames.
1. Completely cut off the outer guide rod
1. Guide rod
2. Remove any welds on the inside or outside of
the track frame.
3. Stack the 2 templates on top of each other, and
align them with the front hole and the bottom
edge of the track frame
hex-socket-head bolt and nut in the front hole to
secure the templates to the frame.
3
(Figure
Figure 6
(Figure 7). Use a
6).
g215023