Removing The Base Cover; Replacing The Base Cover - Dell Studio 1555 Service Manual

Back to Contents Page
Base Cover
Dell Studio™ 1555 Service Manual
Removing the Base Cover
Replacing the Base Cover
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
disconnect the modem from the wall connector and the computer, and remove any other external cables from the computer.
CAUTION:
surface (such as a connector on the back of the computer).
CAUTION:
is not covered by your warranty.
CAUTION:
before working inside the computer.
Removing the Base Cover
1. Ensure that the computer is turned off.
2. Remove the battery (see
3. Loosen the three captive screws on the base cover and lift the cover off the computer at an angle as shown in the figure.
1 base cover
3 captive screws (3)
Replacing the Base Cover
1. Align the tabs on the base cover to the bottom of the computer.
2. Tighten the three captive screws on the base cover.
3. Slide the battery into the battery bay until it clicks into place.
Back to Contents Page
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Before performing these procedures, turn off the computer, disconnect the AC adapter from the electrical outlet and the computer,
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To help prevent damage to the system board, remove the main battery (see "Before Working Inside Your Computer" on page 10)
Before Working Inside Your
2 tabs
UserManuals.info
Computer).