English IMPACT DRILL DCD999 Congratulations! The vibration and/or noise emission level given in this information sheet has been measured in accordance with a standardised test You have chosen a D WALT tool. Years of experience, thorough given in EN60745 and may be used to compare one tool with product development and innovation make D WALT one of the another.
Page 7
English 5) Battery Tool Use and Care d ) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached a ) Recharge only with the charger specified by the to a rotating part of the power tool may result in manufacturer.
English Safety Instructions When Using Long Mains Plug Replacement (U.K. & Ireland Only) Drill Bits If a new mains plug needs to be fitted: • Never operate at higher speed than the maximum • Safely dispose of the old plug. speed rating of the drill bit. At higher speeds, the bit is likely •...
English Charger Operation • Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug Refer to the indicators below for the charge status of the and cord. battery pack. • Make sure that cord is located so that it will not be Charge Indicators stepped on, tripped over, or otherwise subjected to damage or stress.
English exposed. Align the slots on the back of the charger with the damaged in any way (i.e., pierced with a nail, hit with exposed screws and fully engage them in the slots. a hammer, stepped on). Electric shock or electrocution may result.
English Transporting the FlEXVOlT Battery Have defective cords replaced immediately The D WALT FLEXVOLT battery has two modes: Use and Transport. Use Mode: When the FLEXVOLT battery stands alone or is in Charge only between 4 ˚C and 40 ˚C. WALT 18V product, it will operate as an 18V battery. When the FLEXVOLT battery is in a 54V or a 108V (two 54V batteries) Only for indoor use.
English Markings on Tool ASSEMBLY AND ADJUSTMENTS The following pictograms are shown on the tool: WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect battery pack Read instruction manual before use. before making any adjustments or removing/ installing attachments or accessories.
Page 13
English Three‑Speed Gearing (Fig. A) accommodate left‑ or right‑ handed users. If the hook or magnetic bit holder is not desired at all, it can be removed from The three‑speed feature of your tool allows you to shift gears the tool. for greater versatility.
Page 14
English switch and remove the battery from the tool when fastener at the desired depth. The lower the number, the lower the torque output. changing acces sories. 2. Reset the torque adjustment collar to the appropriate WARNING: Always ensure the bit is secure before starting 5 ...
English MAINTENANCE Rechargeable Battery Pack Your power tool has been designed to operate over a long This long life battery pack must be recharged when it fails period of time with a minimum of maintenance. Continuous to produce sufficient power on jobs which were easily done satisfactory operation depends upon proper tool care and before.
Page 16
Belgique et WALT - Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be Luxembourg België en Luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)