Husqvarna 596542901 Manual page 11

STEP 5
CUSTOMIZE THE CANOPY ANGLE (FIG. 1-3)
Note: Fabric shell will be tight when properly assembled.
PARTS NEEDED
1
F
F
canopy skin removed for illustration
Loosen the four Nylock Nuts (F) attached to the Square U-Bolts. Repeat for the Nylock
Nuts on the opposite side. Pull the Canopy Skin/Frame down until the skin is taught
across the Roll Over Protection Bar. Tighten all Nylock Nuts.
3
Installation complete.
NONE
2
J
J
canopy skin removed for illustration
Hand loosen the two Five Arm Knobs (J) on each side of the Roll Over Protection
Bar. The Canopy is now free to pivot up and down, adjust for best visibility, weather
protection and headroom. When you are satisfied with the position of the Canopy,
hand tighten all four Five Arm Knobs.
11
TOOLS NEEDED
NONE