Using The Appliance - Kenwood JETFORCE VC2791/2 Manual

VACUMM CLEANER ASSEMBLY
WARNING: Before fitting or removing the attachments, always make sure that the vacuum cleaner
has been unplugged from the power mains.
- Fit the suction device (14) into the air inlet opening (6) and press it in until it clicks into place. To
remove it, it is necessary to press the two release buttons (2) at the same time and to pull it out
(Fig. 2).
- Insert the telescopic tube (12) into the handle (Fig. 3).
- Push the slider device (13) forwards and pull the bottom section of the tube out to the required
length (Fig. 4). Then simply release the slider and the device will return to its original position.
- Fit the required attachment to the telescopic tube.

USING THE APPLIANCE

Caution: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid
any possible damage to the cleaner itself.
First of all, before using this appliance, unwind the power cord completely and plug the appliance
into the mains socket.
To switch on the appliance, press the foot switch (3) on the vacuum cleaner. While using the appli-
ance, pull it along behind you as if it were a trolley.
Important: In some cases, the appliance may "whistle" when switched on. This is not a fault and
the noise will go away with time.
Secondary air valve (19)
The secondary air valve (19) is on the hand grip (18) and it is used to regulate suction power. The
wider the valve is opened, the less the suction power and vice versa.
- To open the valve, push it upwards and to close it, push downwards.
Open the valve to prevent curtains and the like from being sucked into the cleaner.
- Minimum suction power for curtains and delicate materials.
- Medium suction power for cushions, mattresses and carpets.
- Maximum suction power for tiled, wood or other resistant floor surfaces that are heavily soiled.
WARNING: Switch off the vacuum cleaner immediately if the air inlets, brushes or telescopic tube
become blocked. Remove the cause of the blockage before switching the vacuum cleaner on
again.
After using the vacuum cleaner
Switch off the appliance after use by pressing the foot-operated switch (3), with your hand or foot.
After this, unplug the appliance and wind the cord back inside its housing by holding down the foot
operated rewinder button (1). The cord will rewind itself immediately inside its housing.
WARNING: While rewinding the power cord, guide it in the right direction by hand to prevent any
risk of injury to yourself.
- 3 -
EN