Kenwood JETFORCE VC2791/2 Manual page 7

EN
Cleaning the air outlet filter
This filter cleans the air one last time before it leaves the vacuum cleaner. To clean the filter, pro-
ceed as follows:
- Upturn the appliance and open the air outlet filter grid (9).
- The air outlet filter can be seen once the grid has been opened.
- Clean the filter in cold water and leave it to dry.
- Refit the clean (or new) air outlet filter into the grid and return this to the appliance, pressing it
down until it clicks into place.
WARNING: Only wash the filter in clean water, without using soap or detergents.
Cleaning the vacuum cleaner
The casing, dust container and filter seats can be wiped with a damp cloth if necessary. No liquid
must enter the vacuum cleaner in the process. Never use heavy-duty cleaning substances (stain
removers, thinners) because they can corrode the plastic surfaces. Only put the plug back into the
mains socket when you are sure that all parts are thoroughly dry.
Important: Do not lubricate or oil any rotating parts, since this could cause dirt and fluff to stick
even further
Cleaning the brushes
While the appliance is switched on, move your hand between the bristles on the brush to free them
of any trapped dust, which will then be sucked into the cleaner.
- 5 -