2.5.2
M.2 E-Key and B-Key Installation
The M.2 E-Key (2230) and B-Key (3042/3052) slots are accessible by removing the
bottom panel.
To access, remove the two (2) screws securing the bottom panel to the chassis, and
then lift the panel off, as shown below.
Follow standard procedures for expansion card installation, aligning the notch on each
M.2 SSD with its respective key slot. For further information regarding the board
location of each slot type, please refer to the module side diagram provided in section
2.2.
Chapter 2 – Hardware Information
36