Installing An Internal Usb Device - HP ProLiant ML30 Gen10 Plus User Manual

Installing an internal USB device

Installing an internal USB device
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. Locate the internal USB port.
8. Plug in the USB device into the internal USB port.
Installing an internal USB device 168