Setting up the server in tower mode
Setting up the server in tower mode
Procedure
Procedure
1. Return the server to an upright position.
2. Connect all peripheral cables to the server.
3. Connect each power cord to the server.
4. Connect each power cord to the power source.
5. If the server is using a non-hot-plug power supply, secure the power cord in the power cord clip on the rear panel.
a. Press and hold the clip retainer (callout 1), and then open the clip (callout 2).
b. Position the power cord inside the clip (callout 3), and then close the clip (callout 4).
6. Power up the server .
Setting up the server in tower mode
59