Sealey LED315 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
1.1. GENERAL SAFETY
DO NOT cover the lens whilst the light is on and allow sufficient time to cool before storing.
8
Ensure the light is fully charged before initial use.
9
DO NOT turn the light on when it is being charged.
8
DO NOT shine directly into your, other person's or animal's eyes.
8
DO NOT allow children to use the light.
8
DO NOT handle or move the light whilst it is being charged.
8
DO NOT use the light if you suspect that the battery or the casing is damaged.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
1.2. ELECTRICAL SAFETY
Use only the USB charging lead supplied to charge the battery.
9
WARNING! It is the user's responsibility to read, understand and comply with the following electrical instructions:
‰
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
9
An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD
(Residual Current Device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an RCCB. You must also read and understand the following instructions concerning electrical safety.
1.2.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.2.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply.
9
DO NOT use if worn or damaged.
8
1.3. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
DO NOT Attempt to open, disassemble, modify or service the battery pack.
8
DO NOT Crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT Expose to temperatures above 60°C (140°F).
8
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with water. If it gets in your eyes, rinse thoroughly with cool water and
9
seek immediate medical attention.
2. INTRODUCTION
15W COB Rechargeable Work Light. 360 Degree rotatable LED light capable of producing up to 1000 Lumens with a built-in rechargeable
lithium-ion 2000mAh battery. Other features include a hanging hook and a strong magnet for multiple applications as well as an emergency
power bank function and power level indicator. Supplied with a USB cable for input/output charging, with a run time of 3hrs and charging time
of 3-4hrs.
3. SPECIFICATION
LED Type: ..................................1 x COB LED
Lens diameter: ...................................... 27mm
Lumen Output: .............. 1000 (high) 500 (low)
Battery: ....................................3.7V 2000mAh
Operating Time: ....................................3-4hrs
Power: ......................................................15W
© Jack Sealey Limited
15W COB RECHARGEABLE WORK LIGHT
LED315
MODEL NO:
Original Language Version
LED315 Issue 1 09/06/22