Socket For Testing - Huawei MU739 Manual

HUAWEI MU739 HSPA+ LGA Module
Development Board Guide
Position
Number
J404
J201

2.3.9 Socket for Testing

The DVK provides two 40-pin sockets for testing. One is J401 (as red circle 17 in
Figure 2-1 ), the other is J402 (as red circle 16 in Figure 2-1 ). Table 2-3 and Table
2-4 show the signal assignment of J401 and J402.
Table 2-3 Signals assignment of J401
Pin NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Issue 01 (2011-12-28)
Mark on the Usage and Configuration
Development
Board
J404 (as red This jump is used to start the module.
circle 11 in Configuration is needed. The module can
Figure 2-1 ) be started only when the two pins are
connected.
J201 (as red
Reserved. No configuration is needed.
circle 12 in
Figure 2-1 )
Pin definition
GND
GND
MIPI_HSI_TX_RDY
MIPI_HSI_RX_FLG
MIPI_HSI_TX_WAKE
MIPI_HSI_RX_DATA
MIPI_HSI_RX_WAKE
MIPI_HSI_RX_RDY
MIPI_HSI_TX_DATA
MIPI_HSI_TX_FLG
/
/
VCC_IN
GPIO3
GPIO4
GPIO2
WAKEUP_OUT
WAKEUP_IN
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Overview of the DVK
Figure
11