Advertisement
Machine Translated by Google
"if you thought it was a malfunction
It may not be a malfunction in the following cases, so please check
again before requesting repair. If you still feel unwell, refer to
"Warranty and After-Sales Service" on page 80 and request repair.
"Is
it a
There is no sound from the
speaker. ÿ Is the volume set to "0"? P.27 ÿ Are you
connected to headphones? P.14
"
hindrance?
There is noise during
playback. ÿ If there are devices such as TVs, PCs, mobile
If
phones, etc. near this unit, keep them away.
It stopped working normally while I was pressing the button.
ÿ Turn off the power and try the operation again.
If it still does not work, perform a reset operation. P.75 The
TV image is distorted or noisy. Common ÿ If a TV using an
you think
indoor antenna is placed nearby, the TV may be distorted or
noisy. In such cases, we recommend using an outdoor antenna.
Connoisseur
Timer playback and timer recording do not work.
Also, when you check the time, "TIME ADJUST" is displayed. ÿ
Did you unplug the power cord or have a power outage?
Please set the clock again. P.18
The display is dark.
Press the DISPLAY button on the remote control and
ÿ
select "DIMMER OFF". P.17 The display is lit even though
Consideration
the power is off. ÿ Is the demo displayed? Please cancel the
demo display. P.15
74
Time adjust
Dimmer
display
Cannot be operated with the remote control. Or it does not
work properly. ÿ Is the + -direction of the dry cell reversed?
P.16 ÿ
Is the dry battery exhausted? ÿ Correctly
set the remote control transmitter to the remote control sensor of the main unit
Are you aiming? P.16 ÿ Is the
distance from the remote control sensor too far?
Or is it too close? P.16 ÿ Is the remote control
sensor exposed to strong light (inverter fluorescent lamp,
Remote controller
direct sunlight, etc.)? P.16 ÿ Are you operating the remote
controls of other devices at the same time?
The power does not turn on
with the remote control. ÿ Is the power cord connected? P.14
Even if MD is inserted, "MD NO DISC" and "Can't READ" are
displayed. The playback sound is interrupted. ÿ Is the disc
scratched? ÿ Are you using it in an unstable place with a lot of
vibration? ÿ Is there a soup phenomenon?
I can't record. ÿ Is
the MD erasure prevention knob open?
P.34
MD
ÿ Trying to record on a playback-only MD (commercially available music software)
Isn't it? P.73
Disk full
Is it "DISC FULL" or "TOC FULL"?
ÿ
off
P.77
The group cannot be used on the MD recorded in the group.
Also, the name display is not displayed correctly. ÿ The
TOC data may have been rewritten on another device.
I will.
1-BIT MD / CD SYSTEM SD-FX10
No disc
Cant lead
Tok full
Advertisement
