Advertisement
ICD OPS D Series Product Overview
4
OPS ON /OFF
⚫
1. Power on：
Press the O/I switch, the OPS computer will be boot up after the IdeaHub is turned
on.
2. Power off：
(1) No AC shutdown. Do not shutdown the OPS computer while it is running;
(2) O/I switch can be used to turn off OPS computer when it doesn't turn on or work,
please follow the next steps to turn off under other conditions: in the OPS
computer operating system, the OPS computer is shut down normally. The
indicator is off, and then use the "O/I" switch to shut down.
Use OPS computer
⚫
1. The OPS computer has been installed on the back of the IdeaHub (when installing
or uninstalling the OPS computer, please make sure that the IdeaHub is power-off,
while it may cause computer to be abnormal).
2. Click the OPS computer icon in the lower-left corner of the IdeaHub homepage to
enter the OPS computer.
Remove the OPS computer
⚫
1. No hot plugging. It is prohibited to directly unplug the OPS computer from the 80-pin
connector when the OPS computer is running or the display is turned on.
2. Ensure that both IdeaHub and OPS computers are not started or running. And the
sidelight on the front panel of IdeaHub has been turned off before you can pull out
the OPS computer from the plug-in terminals. Please pay attention to maintaining
the level of the OPS computer to avoid evident up and down twisting and pulling out.
Operation and Maintenance
Figure 4-1 Schematic diagram of O/I switch
O/I switch
6
Advertisement
