Advertisement
Installation
NOTICE:
It is essential that full voltage and amperage
always be available as it takes full power to grind
coffee.
Please read this manual before operating the grinder.
1. Carefully remove grinder from carton.
2. Place grinder in position on shelf, counter
or other flat surface. For safe operation the
appliance must be placed on a stable
horizontal surface in a vertical position.
3. Plug grinder into the specified power
source. (Check rating plate on back of unit
for voltage and amperage requirements.)
Do not use an extension cord.
4. Fill hopper with whole bean coffee.
5. Grind a small amount of whole bean coffee
following
operating
described in this manual
6. If there is any problem, consult the
Troubleshooting Guide in this manual.
Operation
Your new coffee grinder is easy to operate and
maintain. Before you place it in service, please have all
personnel
familiarize
instructions. Keep this manual in a convenient place for
ready reference.
How to Operate
1. Turn the selector knob to the desired grind
setting.
2. Fill the hopper with the desired type and
amount of whole bean coffee. Close the
lid.
3. Place the bag underneath the spout.
4. Press the start button. *810 model - Press
the grinder switch to the ON position.
5. The grinder will automatically stop when
the bag is removed.**
* 810 model - Once coffee is ground, press
the grinder switch to the off position or
grinder will continuously run.
** On models 835 and 875 the stop button
may be pressed after the grinder has
completed grinding.
6. Remove bag from coffee spout once coffee
is ground.
Grinds
Before shipment, this grinder has been tested with
coffee and has been accurately adjusted to deliver
ground coffee to normal auto drip specifications.
The Grinding Burrs are made of an extremely hard and
wear resistant material. From time to time, grind
800 Series Coffee Grinders
instructions
as
themselves
with
these
Electrolux
adjustments (see following instructions) may be
necessary. If the grind runs coarser than expected after
normal adjustment and the grind time has increased,
the burrs may have excess wear and should be
replaced. New burrs should always be installed as a
pair, never one or the other, as they are accurately
ground and lapped in pairs. Old burrs cannot be
resharpened.
Grind Adjustment
WARNING: ELECTRIC SHOCK HAZARD!
Unplug grinder to prevent electrical shock.
Tools required: Phillips screwdriver
Large blade screwdriver
Pliers
1. Remove all coffee from the hopper.
2. Set selector knob to the finest setting
(Espresso or Turkish) depending on the
model.
3. Loosen both knob retainer screws in
selector knob one turn only.
4. While pressing the bag switch, located
behind the spout, press the start button so
that
the
grinder
adjustment.
*810 model - Press the on or start button
so that the grinder will run during
adjustment.
5. With the grinder still running, turn the
adjusting screw in the center of the selector
knob slowly to the right until a slight
chirping noise is heard. Immediately turn
the adjusting screw to the left until
chirping noise stops. This is the finest grind
obtainable.
6. Tighten both of the knob retainer screws.
Once the finest grind has been set, the
other grind settings will automatically set
correctly.
7. Press the stop or off button.
will
run
during
7
Advertisement
