Advertisement
Adjust the print alignment (recommended)
8
To adjust the print alignment before using your machine, press [Start].
Follow the LCD instructions
to print the Adjustment Sheet.
The black circle mark is
located in the upper left corner
of the sheet.
Connect your computer or mobile device to your machine
10
Follow these steps to complete the setup using one of the connection types available on your machine.
Visit
setup.brother.com
to download and install
Brother software.
setup.brother.com
NOTE
(Windows) You must install the Brother software if you
want to use the Cut Print function.
Can't Connect? Check the following:
Wireless network
Wired network
USB connection
Manual wireless setup
11
If the wireless setup is not successful, try to set up the connection manually.
Find your SSID (Network Name) and Network Key
(Password) on your wireless access point/router
and write them in the table provided below.
SSID (Network Name)
Network Key (Password)
SSID: XXXXXXX
Network Key: XXXX
If you cannot find this information, ask your network
administrator or wireless access point/router
manufacturer.
For detailed machine information and product specifications, see the Online User's Guide at support.brother.com/manuals.
Place the Adjustment Sheet
face down on the scanner
glass.
Make sure the black circle
mark is in the upper left corner
of the scanner glass.
Follow the on-screen instructions and prompts.
NOTE
For Wired Network Connection and USB Connection,
locate the correct port (based on the cable you are using)
inside the machine as shown.
Restart your wireless access point/
router (if possible).
Disconnect the cable.
Go to your machine, and press
[Find Wi-Fi Network] > [Yes].
Follow the LCD
instructions and
complete adjusting the
alignment.
When finished, remove
the Adjustment Sheet
from the scanner glass.
Restart your machine and
computer, and then go to
>
9
Clear the LCD notifications
If any notifications appear on the LCD, clear them by
pressing [OK].
Setup Finished
You can now print and scan using your machine.
To check for the latest firmware, visit
support.brother.com/up7.
Important Notice for Network Security:
The default password to manage this machine's
settings is located on the back of the machine
and marked "Pwd". We recommend immediately
changing the default password to protect your
machine from unauthorised access.
If still not successful, go to
10
.
If still not successful, visit
for FAQs and Troubleshooting.
Select the SSID (Network
Name) for your access point/
router and enter the Network Key
(Password).
When the wireless setup is
successful, the LCD displays
[Connected].
If setup is not successful, restart
your Brother machine and your
wireless access point/router, and
11
repeat
.
© 2022 Brother Industries, Ltd. All rights reserved.
11
.
support.brother.com
Go to
to install
10
software.
Advertisement
