Configuration Parameter Data - 4Byte - Hitachi HX-RIO3 Series User Manual

13
2.6 Configuration Parameter Data – 4byte
Bit No Bit 7
Byte 0
Byte 1
Byte 2
Byte 3
■ Gate Mode (Gate Function)
This Gate Function will operate in one of five modes (Store/Continue, Store/Wait/Resume, Store-Reset/Wait/
and Store-Reset/Start).
* Store/Continue
When G ph are raising edge, The Stored Count Value register will get counting value by Current Count Value
register. Next Current Count Value will do counting continue.
Below example picture shows timing waveforms of Store/Continue.
* Store/Wait/Resume
When G Ph are rising edge, The Stored Count Value register will get counting value by Current Count Value
register and waits the Current Count Value until falling edge. Next G Ph will be filling edge and Current Count
Value register resume counting.
Below example picture shows timing waveforms of Store/Wait/Resume.
* Store-Reset/Wait/Start
When G Ph are rising edge, The Stored Count Value register will get counting value by Current Count Value
register and Current Count Value register reset at the same time. The Current Count Value register wait until G
Ph falling edge. Next Current Count Value register start counting.
Below example picture shows timing waveforms of Store-Reset/Wait/Start.
* Store-Reset/Start
When G Ph are rising edge, The Stored Count Value register will get counting value by Current Count Value
register and Current Count Value register reset at the same time and the register start counting.
Below example picture shows timing waveforms of Store-Reset/Start.
Bit 6 Bit 5 Bit 4 Bit 3
Reserved
Reserved
Reserved
Reserved
HX-RIO3 Series
Bit 2 Bit 1 Bit 0