Table of Contents
Advertisement
51
11. Connect the cable between the RAID controller and the system to recover
original state
12. Put Setup Date Label to the place that you notice easily such as system case.
13. Install the side cover on the server. Connect power cord to the receptacles to
recover the original state and power on the system.
14. To confirm whether the RAID controller is recognized from system after OS
started. In detail, refer to [2-2. Checking by Utility].
Universal RAID Utility may not able to recognize the battery pack if it is charged only
at the minimum level (or uncharged). If this occurs, charge the battery pack for nine
hours or longer. Then reboot the server and try to recognize the battery pack again
by using Universal RAID Utility.
Notice
The battery pack is recyclable. To inquire about it, contact your service
representative or bring it to the nearest recycle agent.
Tips
Advertisement
Table of Contents
