Pioneer S-ST100NXT Setup Instructions

S-ST100NXT
For instructions on how to connect the speak-
ers to the rest of the system and specifica-
tions, please see the SX-SW950 instruction
manual.
Assembling the speaker stand
1 Pass the speaker cord from the base, up through
the speaker stand.
It's easier if you loosly twist the two strands of
the speaker cord together, as shown in the
diagram below.
2 Connect the speaker cord to the speaker terminal.
• Connect the speaker cord before you attach the
speaker to the stand.
• The speaker cords and speakers are color
coded. Match up the speaker cords with their
respective speakers.
• Open the speaker terminals by lifting the tab,
then insert the wire of the speaker cord into the
terminal. Release the tab to secure. Connect the
colored half of the speaker cord to the red
terminal; the other half to the black terminal.
Colored
cord
* Place the speakers on a level surface when
connecting.
3
*
4
Colored
label
Setup Instructions
Fix the speaker to the stand using two large
screws.
If there is an excess length of speaker cord after
fixing the speaker to the stand, steady the base
of the stand with one hand and gently pull the
excess speaker cord with your other hand.
Attach the cover plate to the speaker/stand
using four small screws.