Table of Contents
Advertisement
Residual risk
Slipping or falling
Burns/abrasions (e.g. heating elements, cold
pan, cooling circuit plates and pipes)
Electrocution
Tipping of loads
Sudden closure
Harm to eyesight and skin
IMPORTANT
If the appliance contains a UV-C emitter, do NOT stare at the light source.
WARNING
The UV-C LED is activated only when the door or sliding doors are closed. If
the led is working and the door/s are open, turn off the appliance immediately
and contact Customer Care Service.
A.9
Transport, handling and storage
• Transport (i.e. transfer of the appliance from one place to another) and handling (i.e. transfer inside workplaces) must occur with
the use of special and adequate means.
• Please refer to indications on packaging for stackability during transport, handling and storage.
• Do not stand under suspended loads during loading or unloading operations. Unauthorized personnel must not enter the work
area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For appliance handling, do not lift and anchor it to movable or weak parts such as: casings, electrical raceways, pneumatic parts,
etc.
• Do not push or pull the appliance to move it, as it may tip over. Use proper tool to lift the appliance.
• Arrange a suitable area with flat floor for appliance unloading and storage operations.
• Appliance transport, handling, shifting and storage personnel must be adequately instructed and trained regarding the safely use
of lifting systems and personal protection equipment suitable for the type of operation carried out.
• When removing the anchoring systems, make sure the stability of the appliance parts does not depend on the anchoring and,
therefore, that this operation does not cause the load to fall off the vehicle. Before unloading the appliance components, make
sure all the anchoring systems are removed.
A.10 Installation and assembly
• The operations described must be carried out in compliance with the current safety regulations and provisions in force in the
country of use.
• The appliance is not suitable for installation outdoors and/or in places exposed to atmospheric agents (rain, direct sunlight, etc.).
• You can stack up to a maximum of three appliances with sliding doors.
• In case of models with drop down door (even only one), you can stack a maximum of two appliances. Do not install them above
110 cm.
A.11 Electrical connection
• The power supply system must be suitable for the rated current of the connected appliance; the connection must be carried out in
compliance with the regulations and provisions in force in the country of use.
• The information regarding the appliance power supply voltage and frequency is given on the data plate.
• Install between the power cable and the electric line a differential thermal-magnetic switch suitable for the absorption specified
on the data plate, with contact gap enabling complete disconnection in category III overvoltage conditions and complying with the
regulations in force.
• After making the connection, with the appliance running check that the power supply does not fluctuate by ±10% the rated
voltage.
• If the power cable is damaged or too short, it must be replaced by the Customer Care Service or in any case by specialised
personnel, in order to prevent any risk.
• The manufacturer declines any liability for damage or injury resulting from breach of the above rules or non-compliance with the
electrical safety regulations in force in the country where the appliance is used.
A.12 Positioning
• Install the appliances, taking all the safety precautions required for this type of operation, also respecting the relevant fire-
prevention measures.
• The weight of the empty appliance is 36 kg.
Description of hazardous situation
The operator can slip due to water, any liquid or dirt on the floor
The operator deliberately or unintentionally touches some components
inside the appliance without using protective gloves.
Contact with live parts during maintenance operations carried out with the
electrical panel powered
When handling the appliance or the packing containing it, using unsuitable
lifting systems or accessories or with the unbalanced load
The operator for normal appliance use could suddenly and deliberately
close the door/s (if present, depending on the appliance type).
Exposure to UV-C rays for appliances with germicidal lamp, in case of door
interlock fault.
7
Advertisement
Table of Contents
Troubleshooting
