Advertisement
Note 1: For the subcode generation method s e l e c t the START/STOP mode. Thus
the AT1P and SUBCODE are synchronized.
Note 2: When replacing the d i s c , re-set the START TIME OF LEAD-IN value on the
DA-7000A.
Note 3: Before sending the subcode sending set up command, the E. START s i g n a l
must be set to the "L" l e v e l . I f the w r i t e r detects the w r i t i n g s t a r t i n g
p o s i t i o n , set E.START to "H" l e v e l .
the subcode.
Note 4: The DA-7000A receives the subcode sending setup command, completes the
i n t e r n a l p r o c e s s i n g and d i s p l a y s SRQ when the subcode sending setup
can be done.
Note 5: Set the p a r t i t i o n number to 00 when FINALIZING should be c a r r i e d out.
Thus the DA-7000A s t a r t s sending
2 9
Advertisement
