Add �Ngerprint And Pin Code; Delete �Ngerprint And Pin Code - Philips 6000 Series Manual

Add �ngerprint and PIN code
1. Open safe door and press the red setting button '
on the battery compartment. After hearing a voice
prompt 'Please enter �ngerprint or PIN code', enter
your �ngerprint as shown in Figure 2. A voice prompt
'Fingerprint entering succeeded.' indicates successful
operation. If the entering fails, there will be a voice
prompt 'Fingerprint entering failed'. The system will
automatically exit if there is no entering in 8 seconds.
Attention:
this product supports a maximum of 30 �ngerprints.
2. After the �ngerprint is successfully entered, you can
continue with PIN code entering. Enter a 3 - 8 digit PIN
code and press '#' to con�rm. There will be a voice
prompt 'Please enter your PIN code again'. Enter the
PIN code again and press '#' to con�rm. There will be a
voice prompt 'PIN code entering successful', indicating
successful operation.
Attention:
Figure 2
this product supports a maximum of 10 sets of PIN codes.
05
Delete �ngerprint and PIN code
As shown in Figure 3, long press the red setting button '
'
compartment for 3 seconds. There will be a voice prompt 'Initialization success-
ful', indicating that all PIN codes and �ngerprints have been successfully deleted
and the safe has restored to factory settings.
Attention
1.
This product does not support deleting single �ngerprint or PIN code.
2. After the system restores to factory settings, 'Vibration alert' and 'Safe mode'
will also return to the initial settings, namely being off.
'on the battery
Figure 3
06