General Information; Safety - Hitachi JR AUTOMATION TPM-MD-200-000 User Manual

Hide thumbs

Table Of Contents

Table of Contents

1. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

2. Any changes or modifications not expressly approved by the manufacturer could void the user's authority to

operate the equipment.

3. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be required to correct the interference

at his own expense.

4. JR Automation TPM products & related equipment must be integrated into the end users manufacturing

system by JR Automation, or by a JR Automation recommended automation Systems Integrator

5. JR Automation TPM products are meant for industrial manufacturing settings only.

6. JR Automation does not manufacture or provide TPM valve stems, only the equipment that is used to

communicate to those stems during tire, wheel, & vehicle manufacturing.

The device shall be used in such a manner that the potential for human contact normal operation is

minimized. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with a minimum distance of 30cm between

the radiator and your body. This device and its antenna(s) must not be co-located or operating in

conjunction with any other antenna or transmitter.

Only personnel who are properly trained and have adequate knowledge and skill related to this product

should undertake any troubleshooting and repair.

It must be assumed at all times that POWER is "ON" so all conditions must be treated as live. This practice

develops a caution that may prevent an accident. Follow posted lockout procedures.

REMOVE LOAD from circuit or equipment before and after maintenance/troubleshooting.

Equipment—NOTE: Test equipment must be checked at regular intervals.

Capacitors MUST be given time to discharge, otherwise it should be done manually with CARE.

When troubleshooting "LIVE" equipment, the necessary precautions must be taken as follows:

a. Follow written safe operating practices.

b. MAKE CERTAIN your tools and body are clear of Ground.

c. Use extra PRECAUTION in DAMP areas.

d. BE ALERT and work without any outside distraction.

BEFORE applying POWER to any equipment, it must be established without a DOUBT that all persons are

CLEAR.

Any CONTROL PANEL DOORS shall be open ONLY when it is necessary to check out the electrical

equipment or wiring. After CLOSING the door, make certain that the disconnecting means is operating

properly with the DISCONNECT HANDLE MECHANISM.

10.

ALL COVERS or junction boxes SHOULD be CLOSED before leaving any job.

11.

BEFORE STARTING, read and understand all WARNING markings and notices.

12.

READ all marking such as nameplates and identification plates.

13.

DO NOT alter circuits unless authorized to do so by the manufacturer.

Modulated Antenna User Manual - Prelim3