Prior To Operation - DeWalt D21585 Manual

WARNIING: Also refer to the drill stand
manual.
1. Fit the mounting bracket to the base of the
machine.
2. Carefully place the machine with the bracket
into the bracket holder on the stand as shown.
3. Secure the machine to the stand by tightening
the bolt with the feed handle.
WARNING: Always mount your drill
firmly to prevent movement.
Mounting and Removing an
Accessory (fig. 4)
This tool uses threaded core bits and adaptors
which thread directly onto the spindle (D).
We recommend to use professional accessories
only.
1. Choose the appropriate core bit for wet drilling.
2. Follow the core bit or manufacturer's
recommendations for mounting the accessory.
You may require an adaptor to fit the bit onto
the spindle.
3. Make sure to place a copper ring (F) between
the spindle and the core bit to facilitate removal
of the core bit after use.
4. Hold the spindle using the open-ended wrench
(L) and tighten the core bit (M) by rotating
clockwise using the open-ended wrench (N).
WARNING: Make sure the entire
assembly is tight before starting the
operation.
Three Gear Selector (fig. 1)
The tool is fitted with a three gear selector (C) to
vary the speed/torque ratio.
1. Release the switch and select the required
position after the motor has come to a
complete standstill.
2. Always align the selector with the marks on the
gear housing.
3. Refer to the technical data to choose the
appropriate gear according to the diameter of
the core bit and the material to be drilled.
4. Do not change gears at full speed or during
use.
Connecting to a Water Supply (fig. 5)
WARNING:
• Never use the tool without the PRCD
delivered with the tool.
• Replacement of the plug or the supply
cord shall always be carried out by the
manufacturer of the tool or his service
organization.
• Keep water clear of the electrical parts
of the tool and away from persons in
the working area.
1. Check that the water hose (P) has been
tightened firmly into the fitting (E).
2. Close the water tap (Q).
3. Connect the water hose to an appropriate
water supply system.
WARNING: Make sure that the pressure
of the water supply is below the max.
pressure as stated in the technical data.
Regulating the Water Flow (fig. 5)
The water tap (Q) on the water hose can be
adjusted to regulate the flow of cooling water
towards the drill bit.
1. To reduce the flow, turn the tap clockwise.
2. to increase the flow, turn the tap
counterclockwise.

Prior to operation

1. Mount the appropriate accessory.
2. Mark the spot where the hole is to be drilled.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
WARNING:
• For proper function, make sure the
environment temperature is not too
cold, machine and accessory is well
maintained and the drill core bit size is
suitable for this machine.
english
29