Advertisement
Please refer to the Instruction Manual prior to installation and startup!
L | Keyboard and Function value |
Measured value, Unit (M12 and M14), status | |
Error and fault codes in case of malfunction | |
M4 | Damping1)2) |
M7 | Zero adjustment3)2) |
M10 | Key and function disable1)5)2) |
M13 | Measured value source1)2) |
M14 | Physical unit1)3)2) |
M15 | Bus address1)2) |
M16 | Device operation mode1)2) |
M17 | Decimal point1)2) |
M18 | Zero adjustment4) |
M19 | Balance LO1)3)2) |
M20 | Balance HI1)3)2) |
1) UP or DOWN change value
2) MODE save value
3) UP and DOWN 2s set value
4) Only display of remaining available measuring range
5) UP and DOWN 2s lock off
F_001 | Key and function disable |
F_003 | Change of device mode currently not permitted |
F_004 | Decimal point unfavourable |
F_005 | Value is read-only |
F_006 | Balance span too small |
F_007 | Measuring range limited |
F_008 | Local operation disabled |
B_004 | Balance span too small |
B_011 | Value not calculated |
B_012 | Electronics defective |
B_015 | Electronics defective, value constant |
B_016 | Sensor error |
B_017 | Lower overrange limit reached |
B_018 | Upper overrange limit reached |
B_031 | Out of service |
U_071 | Last usable value |
U_072 | Substitute value |
U_075 | Substitute value constant |
U_079 | Initial value |
U_080 | Maintenance alarm |
U_081 | Lower measuring range reached |
U_082 | Upper measuring range reached |
Good | |
G_132 | Parameter changed |
G_137 | Lower warning limit reached |
G_138 | Upper warning limit reached |
G_141 | Lower alarm limit reached |
G_142 | Upper alarm limit reached |
G_164 | Maintenance required |
0 | Output |
1 | Secondary variable (Pressure) |
2 | Primary variable |
3 | Sensor temperature |
4 | Electronics temperature |
5 | Secondary variable 3 |
6 | Counter output |
7 | Sensor pressure value |
0 | Profile 3.0 device (1AI) |
1 | SITRANS P DS III PA Profile 3.0 |
128 | Profile 3.0 Gerät (1AI, 1TOT) |
Can be read from the approval label
FW: aaaa. bb. cc
HW: xx. yy. zz
See operation instructions, type plate and certificate of conformity http://www.siemens.com/sitransp
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the SITRANS P300 that isn't answered in the manual? Leave your question here.