Viewing Battery Status; Charging / Recharging - DeWalt DXAELJ16 Instruction Manual

Viewing Battery Status

• The Battery Status LED Indicators indicate the battery charge
level as follows:
• If the battery charge level is at full capacity, all three Battery
Status LED Indicators light.
• If the battery is at partial charged, two Battery Status LED
Indicators light.
• If the battery is nearly empty, only one Battery Status LED
Indicator lights. The unit should be charged at this time.
• If the battery is completely empty, only one Battery Status LED
Indicator flashes. The unit MUST be charged at this time or the
unit's built-in low voltage protection will activate and the unit will
automatic shut down.

CHARGING / RECHARGING

This unit is shipped in a partially charged state. Charge the unit after purchase, before first use, and
after each subseuent use until all three blue Battery Status LED Indicators light when the Power
Button is pressed (with the adapter unplugged from the unit).
IMPORTANT: When the unit is not in use, we recommend that the battery is charged at
least every 3 to 6 months.
CAUTION – TO AVOID THE RISK OF PROPERTY
DAMAGE Failure to keep the battery charged will cause permanent damage and result in
:
poor performance.
NOTES:
• When the Type A USB port is in use in the charging process, the
Type C port will have no output. Pressing the Power Button
during the charging process will only control the LED Light.
• When the unit battery is fully charged, the charging process will
terminate and the unit will automatically shut down.
• A 2A USB is required in order to recharge the unit (2A AC and
DC charging adapters included).
• During the charging process, the unit will stop charging if the
battery of the unit is overheated due to extensive use or
recharging. The charging process will automatically resume
after a cool down period.
CHARGING/RECHARGING USING THE 120 VOLT AC/USB
CHARGING ADAPTER
IMPORTANT: Always connect the 120V AC/USB Charging Adapter
to the 120 Volt AC power source (using the USB Charging Cable)
BEFORE connecting it to the unit.
1. Make sure the Power Button is turned off (the Battery Status LED
Indicators are not lit).
2. Insert one end of the USB Charging Cable into the 120V AC/USB
Charging Adapter.
3. Insert the 120V AC/USB Charging Adapter into a standard 120
volt AC wall outlet or a functioning 120 volt AC power source.
4. Lift up the protective cover of the USB ports. Insert the other end
of the USB Charging Cable into the unit's Type A USB port.
5. The blue Battery Status LED Indicators will gradually light up (left to
right) to indicate the unit is charging.
6. Charge for approximately 6 hours or until the unit automatically
shuts down.
7. Unplug the 120V AC/USB Charging Adapter from the 120 volt AC
power source, then disconnect the USB Charging Cable from the
120V AC/USB Charging Adapter, and then from the unit's Type A
USB port.
8. Press the Power Button to turn the unit on. When all three blue
Battery Status LED Indicators light, the unit battery is fully charged.
9. Store the 120V AC/USB Charging Adapter and USB Charging
Cable in a safe place.
10