Cleaning And Care; Cleaning The Dryer; Cleaning The Exhaust Duct; Cleaning The Moisture Sensor - Bosch MISTCARE Nexxt 500 Series Operating, Care And Installation Instructions Manual

Cleaning and care

d
CAUTION
The access panel located on the
bottom left of the dryer is for Service
Access and is to be opened only by
an Authorized or Qualified Service
Technician. (Panel may be hidden
from view by door extension).
access panel

Cleaning the dryer

d
WARNING
TO AVOID
RISK OF EXPLOSION!
Never use solvents or highly
flammable liquids for cleaning.
NOTICE
Incorrect cleaning may damage the
dryer. Do not spray with a water jet.
Do not use scouring agents or
all purpose cleaners. Do not use
steam cleaners.
Wipe the housing and fascia with a soft
cloth and soapy water only.
Wipe the drum, door seal and inside of
the door with a damp cloth only.
All manuals and user guides at all-guides.com

Cleaning the exhaust duct

Inspect and clean the exhaust ducting
at least once a year to prevent
clogging. A partially clogged exhaust
will lengthen the drying time and will
result in poor performance of the dryer.
Turn off the circuit breaker
q
Pull out power supply plug
q
Close the shut off valve.
q
Disconnect the duct from the
q
dryer.
Vacuum and reconnect the duct.
q
d WARNING
Remove gas connection before
moving the dryer to clean the duct.
Be careful not to damage the gas
connection when cleaning the duct.
Refer to page 10 for instructions on
how to re-establish the gas
connection.
Cleaning the moisture
sensor
The moisture sensor has to be cleaned
because a fine layer of transparent
buildup is deposited on the sensors.
This deposit can easily be removed by
wiping the sensors (the two bars next
to the lint filter) with a cloth and a little
white vinegar.
Use white vinegar only!
Clean the moisture sensor once a
month.
Cleaning the bearing
shield
Over time, fluff from the drying process
collects in the bearing shield.
This fluff can be easily removed using
your vacuum cleaner, at least once a
month.
Cleaning the MISTCAREt
Nozzle
Once a year inspect the nozzle outlet.
If you suspect blockage, wipe the
outside of the nozzle with a cloth
moistened with vinegar. If the nozzle is
completely blocked, consult the
troubleshooting guide (see page 26) for
removal and cleaning instructions. If
the nozzle remains blocked, call
customer service (see page 26).
23