Trimming Hair; Using The Taper Lever; Cleaning, Maintenance And Storage; Disposal - Silvercrest PD-8890 Operation And Safety Notes

lock into place in the side catches on both sides
of the blades .
1

Trimming hair

Plug the mains plug into a socket.
Slide the ON/OFF switch
sition to turn the product on.
Start by cutting a little hair until you are familiar
with the length of the hair. Every guide comb
trims hair. Start with the longest guide comb
and use a different guide comb
hair shorter.
Never run the product through the hair with
pressure or too fast to ensure even results.
Use the hairdressing comb
in the direction of growth, carefully attach the
longest guide comb
run the product up from the bottom at the side
of the head. Press the product against the hair
with the teeth of the guide comb
Lift the product and slowly run it through the
hair. Only cut a little hair every time. Repeat at
the back of the head and on the sideburns.
When you are satisfied with the result, slide the
ON/OFF switch
3
turn the product off.
Unplug the mains plug from the socket after use.

Using the taper lever

Use the taper lever
2
ting length without using a guide comb
the taper lever all the way up, the cut will be
2
very close and the hair will be very short. Moving
the taper lever down gradually increases the
2
cutting length. In the lowest position, the hair will
stay about the same.
Before releasing the taper lever
first unplug the mains plug from the socket.
Regularly unscrew the blades
all hair trimmings.
When reattaching the blades
are set correctly. The blades
justed as follows:
34 GB/MT
to the "ON" po-
3
to cut the
11
to comb the hair
7
to the blades and
11 1
facing up.
11
to the "OFF" position to
to gradually change the cut-
. With
11
, always
2
and remove
1
, verify they
1
can be ad-
1
- Reattach the blades
not tighten the screws yet.
- Move the taper lever
- Move the top blade
lel) with the bottom blade. Verify the two
blades
1
- Now tighten the screws and verify the blades
cannot be moved.
1
Cleaning, maintenance and
11
storage
11
The product, mains cable and mains plug must
not be immersed in water or other liquids.
Always unplug the mains plug from the socket
before cleaning the product.
Do not use aggressive or abrasive cleaning
agents.
Remove the guide comb
by pushing up on the guide comb
1
your thumb.
Wipe the product with a slightly damp cloth.
Clean the blades
with the cleaning brush
Regularly oil the blades
chapter "Oiling the blades".
If the product will not be used for an extended
period, attach the blade guard
blades . You can hang the product up by
1
the hanging loop

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics/20–22: paper and fibre-
board/80–98: composite materials.
to the product but do
1
at the side down.
2
until it is even (paral-
1
are offset by 1.2 mm.
from the blades
11
and guide combs
1
.
8
as described in the
1
to the
10
.
4
with
11
11