Advertisement
Quick Links
36 Recycler Kit
Proline Mid–Size Floating Deck Mowers
Part No. 105–3180
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION
Baffle
Bolt, 5/16 x 1 inch
Bolt, 5/16 x 2–3/4 inch
Lock nut, 5/16 inch
Kicker
Bolt 5/16 x 1 inch
Lock nut, 5/16 inch
Recycler blade
Preparing the Mower
1. Remove the mower and belt. See the Operator's Manual
for instructions.
2. Thoroughly clean the mower. All debris must be
removed to ensure kickers and baffle will fit properly
against mower.
3. Repair all bent or damaged areas of mower and replace
any missing parts.
4. Tip the mower upside down and block up ends to ease
installation of recycler components.
Warning
Open holes in the mower exposes you and others to
thrown debris. Debris thrown out of holes in the
mower can cause injury.
Never operate mower without hardware
mounted in all holes in mower.
Install hardware in mounting holes when
mulching baffle is removed.
2002 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
QTY.
1
2
Installing the baffle
2
4
2
4
Installing the kickers
4
2
Installing the blades
1
Form No. 3328-137
Installation Instructions
USE
All Rights Reserved
Printed in the USA
Advertisement
Related Manuals for Toro 105-3180
Summary of Contents for Toro 105-3180
- Page 1 Never operate mower without hardware mounted in all holes in mower. Install hardware in mounting holes when mulching baffle is removed. 2002 by The Toro Company 8111 Lyndale Avenue South All Rights Reserved Bloomington, MN 55420-1196 Printed in the USA...
- Page 2 Installing the Baffle Important Make sure the bolt heads are installed on the inside of the cutting chamber. 1. Place the baffle inside the front of the cutting chamber (Fig. 2). 2. Position the baffle so the outside ends are tight against the cutting chamber and there is equal distance between the baffle radius’...
- Page 3 Installing the Kickers Important Make sure the bolt heads are installed on the inside of the cutting chamber. 1. Measure from the spindle center lines, and locate kickers as shown in Figure 3. 2. Holding kickers tight against the cutting chamber, mark and drill a hole for each kicker (11/32 inch dia.) (Fig.
- Page 4 Installing the Recycler Blades Removing Baffles for Side Discharge Cutting 1. Hold the blade end using a rag or thickly-padded glove. Remove the blade bolt, blade stiffener and blade from Note: Keep the rear 3 kickers attached to the mower. the spindle shaft (Fig.