Advertisement
Figure 4
1. Bell-crank yoke
4.
Adjust the PTO engagement as directed in the
Adjusting the Mower Belt Tension section in the
traction unit Operator's Manual.
5.
Check the adjustment of the PTO safety switch
as directed in the Adjusting the Mower Belt
Tension section in the traction unit Operator's
Manual.
6.
Check the deck drive belt routing
refer to the Adjusting the Mower Belt Tension
section in the traction unit Operator's Manual to
adjust the deck drive belt.
Important:
Ensure that the belt is on the
correct side of the belt guide under the
engine frame and adjust the belt guide.
Figure 5
PTO engaged
1. To engine drive pulley
7.
Check and adjust the blade brake; refer to
the Adjusting the Blade Brake section of the
Operator's Manual.
g237288
2. PTO engagement linkage
(Figure
5);
g015218
3
Installing the Guards
Parts needed for this procedure:
1
Center discharge guard
2
Bolt (M8 x 25 mm)
4
Washer (M8–17)
2
Locknut (M8)
1
Drive pulley guard
2
Carriage bolt (M10 x 25 mm)
2
Heavy washer (M10)
2
Spring washer (M10)
2
Nut (M10)
1
Underside guard
1
Drag shield
Procedure
1.
Install the center discharge guard beneath the
machine between the engine frame and the
cutter deck.
1. Bolt (M8 x 25 mm)
2. Washer (M8–17)
3. Washer (M8–17) and
locknut (M8)
A.
Remove the center nut, bolt and washers
from the center fixing on the deck
3
Figure 6
4. Center bolt and washer
5. Center discharge guard
(Figure
g237371
6).
Advertisement
