Advertisement
the belt guide under the engine frame and adjust the
belt guide.
1
PTO engaged
1. To engine drive pulley
10. Check and adjust the blade brake; refer to the
Adjusting the Blade Brake section of the Operator's
Manual.
11. Install the center discharge guard between the engine
frame and the cutter deck.
1. Bolt (M8 x 25 mm)
2. Washer (M8–17)
3. Center discharge guard
A. Remove the center nut, bolt and washers from
the center fixing on the deck (Figure 6).
B. Install the guard to the traction unit using 2
bolts (M8 x 25 mm), 4 washers (M8–17), and 2
locknuts (M8) in the lower hole on the engine
frame (Figure 6).
C. Secure the front of the guard to the deck using
the center bolt, washer, and nut you removed
previously (Figure 6).
12. Refer to the Adjusting the Height of Cut section in
the Operator's Manual and check/adjust the height
1
Figure 5
Figure 6
4. Center bolt and washer
5. Washer (M8–17) and
locknut (M8)
setting of the rear axle depending on what height of
cut is required.
13. Install the traction wheels to the hubs and secure
with drive wheel lug nuts. Torque Nuts to 122 - 129
N-m.
14. Lower the unit to the ground.
15. Install the drive pulley guard to the rear of the
engine frame with 2 carriage bolts (M10 x 25 mm),
heavy washers (M10), spring washers, and nuts
(M10)(Figure 7). Ensure that you center the guard
g015218
on the engine frame.
1. Carriage bolt (M10 x 25
mm)
2. Drive pulley guard
3. Heavy washer (M10)
16. Test fit the underside guard and adjust the position
of the drive pulley guard if necessary (Figure 8).
1. Underside guard
2. Drag shield
17. Install the underside guard and drag shield to the
drive pulley guard and secure them with the bolts
3
1
2
3 4
G018373
Figure 7
4. Spring washer
5. Nut (M10)
Figure 8
3. Bolt, captured in the
lanyard
5
Advertisement
