Sanyo MLR-350 Instruction Manual page 12

NAME AND FUNCTION OF PARTS
6. Inner door
This glass inner door minimizes the outflow of air when the cabinet door is opened.
7. Door switch
When the door is opened, the chilled air circulation fan stops, minimizing the outflow of chilled air.
8. Air exhaust vent
.9. Air intake vent
Jt , y Power switch (model without CE mark)
ON/OFF switch for all electric sources includi � g outlet.
10. Power switch with circuit breaker (model with CE mark)
This switch for all electric sources.
dealer or the service station after disconnected the power supply plug.
&WARNING
Never disassemble, repair, or modify the unit yourself. Any such work_ carried out by an unauthorized
person may result in fire or injury due to a malfunction.
Disconnect the power supply plug if there is something wrong with the unit. Continued abnormal
operation may cause electric shock or fire.
&CAUTION
Connect the unit to a power source as indicated on the rating label attached to the unit. Use of any
other voltage or frequency other than that on the fpting label may cause fire or electric shock.
11. Switch box
12. Side door
5 fluorescent -lamps are mounted inside of the side doors (right and left).
fluorescent lamp or a glow starter.
13. Shelves
The shelves can be adjusted vertically.
14. Evaporating tray
Catches water from automatic defrosting and allows it to
evaporate.
Note:
Before using the unit, fasten the evaporating tray on the rail,
which extends from the left side of the frame at the bottom.
If the trap is not properly fastened, water may drip.
the figure.)
15. Data input/output port (Back side of the unit)
16. Frost observation window
17. Dehumidifier mode switch
18. Humidifier duct (MLR-350H, MLR-350HT only)
19. Water supply tank (MLR-350H, MLR-350HT only)
20. Water supply inlet (MLR-350H, MLR-350HT only)
21. Key lock switch
Turn this key lock switch off before inputting the setting value in the control panel.
is input, turn this key lock switch on.
22. Access hole
When an instrument that requires a measuting cable and power cord is placed inside the cabinet, the cable
and cord can be led through this access hole. When a cord is led through, use the cap to prevent aif'from
coming in or out.
When the operation of the unit _ is stopped by this breaker, contact with
},,
,.;
(Refer to
This prevents the setting value from being changed by accident.
11
Open the door to replace a
14
19
20
••••
When the setting value
Fig. 1
Fig. 2