Sanyo MLR-350 Instruction Manual page 26

J
_U_ M _ A _ 1 1_c;_
A_U_I
__
1
Name and function of parts
1. RECORD key
Turns record ON or OFF on the recordeL
is turned on, LED is lit
2.FEED key
Conducts paper feeding. When the recorder is in OFF mode,
and the FEED and RECORD keys are pressed simultaneously
for approximately 2 seconds, test printing starts.
3. AD chang eover switch
Allows switching between analog and digital printing.
4. Printer lever
Paper setting
&
WARNING
Always disconnect the power supply plu g before setting the recording paper in the recorder to prevent
electric shock or injury.
Conduct setting of recording paper according
1. Hook the printer lever with the right forefingeL Then turn
°
90 in the direction of the arrow in the upper figurR
2. As shown in the figure, make sure that the recording
surface of the recording paper is face up.
unrecorded papers in the receiver with the top end toward you.
Do not place as shown·with the mark of cross (X) in the lower
figure.
3. Manually remove the recording paper from the recording
paper receiving tray and put U through the paper thrusting
section of the p rinter (shown by the slant line in the figure).
Continue pressing the FEED key, while slightly pressing the
recording paper with both hands, until recording paper is
inserted.
4. When the recording paper is inserted, release both hands
and return the printer lever to the original place at a 90
Continuously press the FEED key until the top end of the
recording paper comes out again.
5. Manually remove 3 pages of the recording paper .
. 6. Place the recording paper drawn out on the receiving section of already recorded papers.
T_ E ....,. M _ P _ E _ RA _ · _ T _U_ R _ E _R_ E _ C _ O _ R _ O _ E _ R
When the recorder
to
t0e following procedure:
Set the
25
°
angle.
__ _
2
3