Water inlet fault
Problem
The / indicator
light flashes on and off.
The dishwasher stops
during a programme.
The / indicator
light flashes.
Fault code or
appears in the display.
Water drainage fault
Problem
The dishwasher stops
during a programme.
The / indicator
light flashes.
Fault code appears
in the display.
Possible cause and remedy
The tap is turned off.
Turn on the tap fully.
Before rectifying the problem, you must:
Switch the dishwasher off with the button.
Water intake is restricted.
Turn on the tap fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
Possible cause and remedy
Before rectifying the problem, you must:
Switch the dishwasher off with the button.
The water outlet is restricted.
There might be water in the wash cabinet.
Clean the filter combination (see "Cleaning and
care - Cleaning the filters").
Clean the drain pump (see "Maintenance").
Clean the non-return valve (see "Maintenance").
Remove any kink or loop in the drain hose.
Problem solving guide
75