Oil Pickup Assembly Inspection; Crankcase Inspection - Polaris RANGER ETX 2015 Owner's Manual

Table of Contents

OIL PICKUP ASSEMBLY INSPECTION

The oil pickup assembly is located in the oil sump cover

1. Remove and discard the oil inlet seal

oil seal is not inside the pickup bore in the

2. Apply white lithium grease to the ID and OD of a a

new oil inlet seal. Install new oil inlet seal into the

crankcase oil pickup bore.

3. Remove the oil pickup assembly fasteners

the oil sump cover

4. Thoroughly clean the pickup assembly.

5. Inspect the oil pickup assembly for cracks and

excessive wear. Replace if necessary.

6. After cleaning and inspecting pickup assembly,

install it into the oil sump and torque screws to

specification.

Oil Pickup Screws:

5 ft-lbs (7 Nm)

1. Remove all traces of gasket sealer from the

crankcase mating surfaces. Inspect the surfaces

closely for nicks, burrs or damage.

2. Be sure alignment pins are in place where used.

3. Be sure oil passages are clean and free of any

cleaning solvent.

9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual

. Verify the

ENGINE / COOLING SYSTEM

Table of Contents