Page 1
Form No. 3451-209 Rev A Light Kit Dingo ® TX 1300 Compact Tool Carrier Model No. 140-4508 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine.
Page 2
Installing the Lights Parts needed for this procedure: Light Brackets g379176 Large bolt Figure 1 Small bolt Large nut • If your machine does not have a plug, drill a 1-inch hole into the control panel. Small bolt Procedure Install the lights to the brackets using 2 large bolts and 2 large nuts.
Page 3
g379044 Figure 4 Install the rear light assembly using 2 small bolts and nuts. g379175 Figure 6 Remove the rear cover and route the rear harness under the rear screen. Use the magnetic wiring harness mount to keep the wiring away from the operator and rear screen. Connect the rear light to the harness and secure with a cable tie.
Page 4
Operation Operating the Lights Completing the Installation Push the switch to turn on the lights. No Parts Required Procedure Turn the battery-disconnect switch to the O position. Close the rear-access cover. Close the hood. Start the machine and verify that the lights function using the switch.