Toshiba D-VR40SF Service Manual page 66

Power Supply & Junction Schematic Diagram < VCR Section >
CAUTION !
Fixed voltage (or Auto voltage selectable) power supply circuit is used in this unit.
If Main Fuse (F1001) is blown , check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
CAUTION ! NOTE:
For continued protection against fire hazard, The voltage for parts in hot circuit is measured using
replace only with the same type fuse. hot GND as a common terminal.
1-13-13
NOTE: BOARD MEANS PRINTED CIRCUIT BOARD.
E9BA1SCP