Huawei NetCol8000-C070 Quick Manual page 19

6.2
(Optional) Teamwork Settings
All teamwork control parameters can be set on the master smart cooling product. Only
Teamwork group No., Air conditioner address, Enable teamwork CAN resistor, Teamwork
function and Networking mode can be set on slave smart cooling products. Other parameters
of the slave units will be modified by the master unit synchronously.
On the home screen, choose
consisting of eight devices as an example.
Item
No. 1
Teamwork
1
group No.
System
1
address
Enable
teamwork Yes
CAN resistor
Teamwork
Enable
function
CAN
network
Networking
mode
FE
network
Number of
systems in 8
this group
Number of
running
6
systems in
this group
Rotation
Enable
function
> Teamwork Settings. The following uses a teamwork group
Setting
2 ...
1 ...
2 ...
No ...
Enable ... Enable
CAN
...
network network
FE
...
network network
/ ...
/ ...
/ ...
7 8 Smart cooling product No.
A teamwork network can contain a
maximum of four groups, which can
be numbered 1 to 4 respectively.
1 1
Smart cooling products in a group
must have the same teamwork group
number.
In a teamwork group, the address (1–
32) of each unit must be unique and
7 8
the unit with the smallest address is
the master unit.
This parameter needs to be set in
No Yes CAN networking. Set it to Yes for the
first and last units.
Enable /
CAN CAN
network
The networking mode selected on
the screen must be consistent with
FE FE
the actual networking mode.
network
/ / The value ranges from 1 to 32.
The value ranges from 1 to the
number of units in the group. Except
/ / the running units in the group, other
units in the group are used as
standby units.
When the rotation function is
enabled, the running and standby
/ / units can work alternately. It is
recommended that the function be
enabled when the load is even.
18
Setting Rule