System Information - Dell OptiPlex 3080 Small Form Factor Service Manual

Table 9. General (continued)
Option
Boot Sequence
UEFI Boot Path Security
Date/Time
.

System information

Table 10. System Configuration
Option
Integrated NIC
SATA Operation
Drives
Smart Reporting
USB Configuration
Front USB Configuration
Rear USB Configuration
Audio
Dust Filter Maintenance
76 BIOS setup
Description
Allows you to specify the order in which the computer attempts to find an operating system
from the devices specified in this list.
This option controls whether or not the system prompts the user to enter the Admin
password when booting a UEFI boot path from the F12 Boot Menu.
Allows you to set the date and time settings. Changes to the system date and time take
effect immediately.
Description
Allows you to control the onboard LAN controller. The option 'Enable UEFI Network Stack' is
not selected by default. The options are:
● Disabled
● Enabled
● Enabled w/PXE (default)
NOTE: Depending on the computer and its installed devices, the items that are listed in
this section may or may not appear.
Allows you to configure the operating mode of the integrated hard drive controller.
● Disabled = The SATA controllers are hidden
● AHCI = SATA is configured for AHCI mode
● RAID ON = SATA is configured to support RAID mode (selected by default)
Allows you to enable or disable the various drives onboard:
● SATA-0 (enabled by default)
● M.2 PCIe SSD-0 (enabled by default)
This field controls whether hard-drive errors for integrated drives are reported during system
startup. The Enable Smart Reporting option is disabled by default.
Allows you to enable or disable the integrated USB controller for:
● Enable USB Boot Support
● Enable Front USB Ports
● Enable Rear USB Ports
All the options are enabled by default.
Allows you to enable or disable the front USB ports. All the ports are enabled by default.
Allows you to enable or disable the back USB ports. All the ports are enabled by default.
Allows you to enable or disable the integrated audio controller. The option Enable Audio is
selected by default.
● Enable Microphone
● Enable Internal Speaker
Both the options are selected by default.
Allows you to enable or disable BIOS messages for maintaining the optional dust filter that
is installed in your computer. BIOS will generate a pre-boot reminder to clean or replace the
dust filter based on the interval set. The option Disabled is selected by default.
● Disabled
● 15 days
● 30 days