Injection Warning Light Remains On After Engine Start - Suzuki Grand Vitara 2011 Manual

Injection Warning Light Remains ON after Engine Start

Wiring Diagram
Refer to "Immobilizer Control System Wiring Circuit Diagram: For Diesel Engine Model".
Circuit Description
When ECM has any DTC(s), injection warning light remains ON after engine starts.
Troubleshooting
Check ECM for DTC(s) referring to "DTC Check: For Diesel Engine Model in Section 1A" and then, go to applicable
DTC diag. flow.
DTC B1701: Transponder Code Error 1/DTC B1710: Transponder Code Error 3
Wiring Diagram
Refer to "Immobilizer Control System Wiring Circuit Diagram: For Diesel Engine Model".
Detecting Condition and Trouble Area
Detecting Condition
Inconsistent transponder data from transponder while
registering ignition key.
Troubleshooting
Step
1 Was "Immobilizer Control System Check" performed?
2 Diagnostic Trouble Code (DTC) Check
1) Check ICM for DTC referring to "Diagnostic Trouble
Code (DTC) Check: For Diesel Engine Model".
Is any DTC other than B1701 and B1710 detected?
3 Registration of the spare ignition key
1) Register the spare ignition key referring to "Registration
of the Ignition Key: For Diesel Engine Model".
Is ignition key registered?
Immobilizer Control System: For Diesel Engine Model 10C-38
Action
Trouble Area
• Transponder in ignition key faulty
• ICM faulty
Yes
Go to Step 2.
Go to corresponding
flowchart for DTC other
than B1701 and B1710.
Replace ignition key
which cannot be
registered.
S6JB0AA324007
S6JB0AA324008
No
Go to "Immobilizer
Control System Check:
For Diesel Engine
Model".
Go to Step 3.
Substitute a known-
good ICM and recheck.