Keyless Start Control Module Power And Ground Circuit Check - Suzuki Grand Vitara 2011 Manual

10E-24 Keyless Start System:
Step
4 Wire harness check
1) Turn ignition switch to OFF position.
2) Disconnect connector from keyless start control module,
steering lock unit and combination meter.
3) Check for open, short and high resistance in following
circuits.
• Ignition knob switch signal circuit
• Keyless start control module and combination meter
CAN communication circuit
Is it in good condition?
5 Keyless start system operation check
1) With remote controller of which ID code is registered in
keyless start control module carried with you, try to turn
ignition knob switch.
Can it be turned to any position other than "LOCK" position?

Keyless Start Control Module Power and Ground Circuit Check

Wiring Diagram
[A]: Keyless start control module connector (viewed from harness side)
1. Keyless start control module
2. Ignition switch
3. Circuit fuse
Troubleshooting
Step
1 Fuse check
1) Turn ignition switch to OFF position.
2) Check circuit fuse and main fuse for condition.
Are fuses in good condition?
Action
5
2
4
[A]
20 19 18 16 15 14
37 36 34 33 32
Action
Go to Step 5.
Replace combination
meter.
6
3
WHT
7
3
WHT/BLK
8
3
YEL
9
BLK G44-9
G44
11 10 9 8 7 6 5
30 29
4. Main fuse
5. Junction block
6. Power source circuit
7. ACC signal circuit
Go to Step 2.
Yes
Repair circuit.
Substitute a known-
good keyless start
control module and
recheck.
1
12V
5V
G44-10
G44-11
G44-15
4 3 2 1
24 23
8. IG ON signal circuit
9. Ground circuit
Yes
Replace fuse(s) and
check for short.
No
S6JB0AA504016
I7JB01A50003-01
No