Table of Contents
Advertisement
8 MONITOR Output Jack (OUTPUT)
MONITOR (BNC) ........... Outputs the signals of the equipment con-
S-VIDEO .......................... Outputs an S video signal, (derived from
AUDIO L and R (RCA) ... Outputs the signal of the equipment con-
9 RGB Output Connector (OUTPUT)
RGB (BNC) ...................... Connected to the RGB input jacks of a
HORIZONTAL (BNC) .... Connected to the HORIZONTAL input
VERTICAL (BNC) .......... Connected to the VERTICAL input jack of
D EXTERNAL CONTROL Connector
Connections are made to this connector when controlling this unit by
external control.
(See the "External Control Mode" section.)
NOTE :
• Use a signal conforming to the standard TV signal when connecting
an input source.
• Using poor quality video tape may cause distortion on the picture.
nected to VIDEO 1 through 5.
the signal of the equipment connected to
VIDEO 1 or VIDEO 2), which has been
divided to a luminance signal (Y) and a
chrominance signal (C).
nected to VIDEO input 1 through 5 and the
AUDIO L and R associated with the RGB
input connector.
The selected video signal is output when
RGB input has been selected and MONI-
TOR button is switched on.
monitor or projector having a 31.5 kHz
horizontal scanning function.
jack of a monitor or projector having a 31.5
kHz horizontal scanning function.
a monitor or projector having a 31.5 kHz
horizontal scanning function.
H/V (BNC) ....................... Connected to the H/V input jack of a moni-
AUDIO L and R (RCA) ... Connected to the audio input jacks of RGB
0 HV POL. Switch
Selects the polarity of the horizontal and vertical output signals.
H .............. Horizontal
V .............. Vertical
Hi ............. Active high
Lo ............ Active low
A PC-CONTROL SW (Switch)
Selects the communications standard of the PC-CONTROL connector.
422 ........... RS-422 standard
232 ........... RS-232C standard
B AC IN Receptacle
Used to connect the supplied power cord.
C PC-CONTROL Connector (15-pin connector)
Connect to a personal computer or other control equipment.
RGB (D-Sub 15 mini) Connector Pin Assignment
5
4
3
2
1
10 9
8
7
6
15 14 13 12 11
tor or projector having a 31.5 kHz horizon-
tal scanning function.
equipment.
Signal to be connected
Pin No.
Red input
1
Green input
2
Blue input
3
4
GND
5
GND
6
Red GND
7
Green GND
8
Blue GND
9
Open
10
Sync GND
11
GND
12
Open
13
H-Sync
14
V-Sync
15
Open
0
A
Advertisement
Table of Contents
