Display Configuration Dialog - NEC SpectraView 2190 User Manual

Display Configuration dialog ( ÿ Windows version only)
Note: Since SpectraView applies all correction curves to the 10 or 12 bit LUT inside the monitor, the video
graphics adapter card LUT is always set to linear.
Test Monitor - Tests the communications with the currently selected display monitor. Clicking this button will
send a command to flash the monitor's screen brightness. If the wrong display monitor flashes then change
the monitor associated with each display can be selected using the listboxes.
SPECTRAVIEW II - USER'S GUIDE | 1
Display Configuration button (
the Display Configuration dialog which is used to configure
SpectraView II if more than one display is used on the system.
See the following section.
This Display Configuration dialog is accessed either from
the Edit menu, or by clicking on the Display: Configure
button in the main SpectraView window.
If more than one display is being used on Windows, it
may be necessary to manually configure the relationship
between the display layout on the Windows desktop, and
the display monitors that are connected to the system.
Correct configuration of this relationship is necessary
so that the display monitor adjustments are sent to the
correct monitor, and that the calibration is performed on
the correct part of the desktop.
A diagram depicting the display desktop layout is shown
and the display monitors associated with each desktop
screen is shown. The monitor associated with each
display can be selected using the listboxes.
Clicking on the display rectangles will also select different
displays on the Windows desktop.
Note: Some video graphics adapters may show several
duplicate displays due to issues with the video drivers for
that adapter. In this case the duplicate displays can be
selected to "None".
Auto Configure - Attempts to automatically detect and
configure the display monitors to the display layout on
the Windows desktop. In most cases this will correctly
configure the correct relationship, but in some cases it
may be necessary to manually configure.
Test LUT - Tests that the video graphics adapter card LUT
(Look Up Table) can be correctly set. Clicking this button
with flash the screen brightness by setting the LUT in the
video graphics adapter card for the currently selected
display. Verify that the correct screen flashes when this
button is clicked.
ÿ
Windows version only) opens