Table of Contents
Advertisement
en Installation instructions
ATTENTION!
The oil from the vacuum pump may leak out when it is
tipped or tilted, and may damage the appliance.
Do not move the appliance if the transport locks for
▶
the pump are not installed.
When uninstalling the appliance, secure the trans-
▶
port locks again before moving the appliance.
Requirement: Use a suitable tool to remove the trans-
port locks and install the oil filter.
Carefully lift the appliance out of the packaging.
1.
Remove the transport lock for the pump from the
2.
top of the appliance.
Secure the transport lock to the rear of the appli-
3.
ance for further use.
16
Install the oil filter.
4.
Place the lid into the opening and move it to the left.
5.
6.
WARNING ‒ Risk of tipping!
After removing the transportation lock, the drawer
may open and the appliance may tip over.
Keep the drawer closed.
▶
Weigh down the appliance with a weight.
▶
Only open the drawer if the tilt protection is in-
▶
stalled.
Remove the transport lock screws.
7.
Insert the power cord at the rear of the appliance.
Advertisement
Table of Contents
