Advertisement
Plug the mains lead to the mains socket.
6
Press the POWER button so that a picture is projected onto the screen.
7
NOTE:
● If "DIRECT POWER ON" in the "OPTION" menu has been set to "ON",
projection will start after the mains lead is connected.
Press the MENU button to display the menu screen, and then press
8
the ▲ or ▼ button to select the "OPTION" menu.
Press the ENTER button, and then press the ▲ or ▼ button to select
9
"LAMP RUNTIME".
Press and hold the ENTER button for approximately 3 seconds.
10
● The "LAMP TIME RESET" screen will be displayed.
NOTE:
● If you press any button other than the POWER button, the "LAMP
RUNTIME RESET" screen will be cleared and the cumulative usage
time for the lamp will not be reset. Repeat the procedure from step
Press the POWER button to turn off the power.
11
● Disconnect the mains lead after the POWER button on the projector
illuminates red.
This will reset the cumulative usage time for the lamp unit to "0".
12
Replace the air filter with the new filter which is supplied as an
13
accessory, while referring to the replacement procedure which
appears in the Operating Instructions for the LCD projector.
Accessory
• Air filter: 1
Web Site : https://panasonic.net/cns/projector/
.
8
Printed in Japan
Advertisement
