Advertisement
Disengage connection block from projector mount assembly (A) by unscrewing captive screw and sliding out
connection block as shown.
CAPTIVE SCREW
Installation To Wood Joist Finished Ceilings,
Exposed Wood Joists, or Wood Beam Ceilings
Drill two 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach projector mount assembly (A) with two
#14 x 2.5" (6 mm x 65 mm) wood screws (F) and two flat washers (E) as shown in figure 1 or figure 2 depending
on joist orientation. Tighten wood screws (F) using 3/8" (10 mm) socket wrench until projector mount assembly (A)
is firmly attached.
Note: Be sure to drill holes into the joist CENTER!
Skip to step 6.
WARNING
• Installer must verify that the ceiling will safely support
the combined laod of equipment and all attached
hardware and components.
WOOD JOIST
A
figure 1
Visit the Peerless Web Site at www.peerlessmounts.com
Accessories listed in the included sheet, as well as other parts,
can be ordered through Peerless by calling 1-800-729-0307 or
visiting www.peerlessindustries.com.
A
FRONT OF
MOUNT
E
F
3 of 8
CONNECTION BLOCK
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
A
figure 2
For customer service call 1-800-729-0307 or 708-865-8870.
WOOD JOIST
FRONT OF
MOUNT
E
F
ISSUED: 11-16-05 SHEET #: 055-9447-2
Advertisement
