Advertisement
Replacement prcedure
J
1) Turn off the Power and then unplug the AC power cord. Wait at least 1 hour
and make sure the lamp unit and surroundings are cool.
2) Use a Phillips screwdriver to loosen the Lamp cover screws (2 screws) and
open the lamp cover.
3) Use a Phillips screwdriver to loosen the Lamp unit screws (2 screws) until the
screws turn freely. Hold the used lamp unit by its base, and pull it gently from
the projector.
Lamp cover fall-
prevention rubber
4) Insert the new lamp unit in correct direction. Tighten the Lamp unit screws (2
screws) securely with a Phillips screwdriver.
5) Close the lamp cover, and tighten the Lamp cover screws (2 screws) securely
with a Phillips screwdriver.
When installing the lamp cover, make sure the lamp cover falling-prevention rubber not be
z
clamped.
6) Clean up the dust on the projector and around the air vents.
7) Slowly pull out the air filters from rear and side.
Air filter (side)
Air filter (rear)
4 -
ENGLISH
Lamp cover screws
Base
Lamp unit screws
Advertisement
