Silvercrest SKPE 3 A1 Operation Instructions Manual page 38

NOTES:
If necessary, hold the bowl
Repeat above steps if the result is not satisfactory .
In order to prevent damage, the drive shaft
pressure or is too much resistance is present .
In order to prevent damage to the brush / bristles, do not over
spin .
If you want to clean additional brushes, repeat the above steps
for each additional brush .
Remove the brush from the rubber collar
Remove the rubber collar
brush cleaning is finished .
Reshape the bristles with your fingers if needed .
Once you have cleaned the last brush, clean the bowl
splash guard
(see "Cleaning and care") . Only use the brushes again
once dry .
38 GB/IE
[ 7 ]
9 ] [
, rubber collars
8 ] [
while the brush is spinning .
1 ] [
.
9 ] [
from the drive shaft
and the main unit
9 ] [
stops if too much
when
1 ] [
,
7 ] [
2 ] [